With the widespread of silicone rubber protective sleeves is applied, silicone rubber protective sleeve orders demand more and more, a lot of customers friend custom silicone products without a certain standard and way, not regularly identified according to the process, technology and the production of lighter, for silica gel set custom processing also does not have a certain understanding, so I want to customize the silicone case is more fans The exploration

 

About the product, the size and structure of the silicone protective sleeve in customized processing, usually the machine tonnage of the silicone sleeve manufacturer is about 200-300 tons. The size range of the mold that can bear the load is about 600MM long, 600MM wide, and 550MM high, so the size of the product can be controlled within 60% of the mold size, so the maximum size of the product is generally no problem if the size of the product is below 400MMI.

Product structure is the key of the silicone mold out of the mold, silicone protective sleeve usually have a gate, such as the size of the product out of the gate and the overall not harmonious overall cannot release will also affect the production, the best case usually buckle main products, so the torque is also part of silica gel structure, ensure that the product can normal production, as far as possible to size when grasp buckle the R Angle Increase to ensure normal demoulding.

 

In the surface of the silica gel protective sleeve appearance, custom demand everyone can judge appearance, and at present, there are a lot of different appearance of silicone products, such as injection, dry lines, laser carving, screen printing, UV, and so on, but many consumers still choose the same spray mist or oil level, specific for the product functional requirements do not affect the appearance quality is different!

 

The thickness and hardness of the silicone sleeve, the thickness depends on your functional requirements and quality of the product, good products usually achieve reasonable conformity in the thickness, will not use too thin, and some customers pretend to be too thin effect, so the function of each product is different. However, for silica gel manufacturers, the thicker the product is, the higher the cost will be. This is a problem point that must exist!

 

Soft hardness is also a top priority, for the need for functional silicone sleeve, a high quality protective sleeve naturally requires hardness, such as the product is too soft may appear loose or deformation, such as the product hardness is too hard may be bad in assembly and damaged when using and so on.

 

So in the customized processing as far as possible to understand the various information to determine the size, color, hardness of the packaging product demoulding structure, the use of requirements can be confirmed after the start of customized processing!